Hi,
I tried to uptade MOBO DH61CR v.0044 following the steps:
"
If the computer's current BIOS version is earlier than 0048:
1. You must first update to version 0048, using one of these methods:
Express Update
iFlash Update
2. Check if the Intel Management Engine (Intel ME) Firmware is version 7 or 8.
a) Press F2 during boot to enter BIOS Setup.
b) Go to the Main > System Identification Information screen
c) The Intel ME version is listed here.
d) Press F10 to exit BIOS Setup.
3. If the Intel ME version is 7.x, use the BE0048.BIO file to do a BIOS Recovery and then check the Intel ME Firmware version again to confirm that version 8.x has been installed.
4. Then you must then update to version 0099 before upgrading to any later BIOS, using one of these methods.
Express BIOS Update
F7 BIOS Flash Update
iFlash Update
5. Update to any later than 0099 BIOS version. Using one of these methods.
Express BIOS Update
F7 BIOS Flash Update
iFlash Update
There are no special steps required for updating from BIOS version later than 0099 to a more current BIOS version.
"
So, after I install 0048, according Intel instructions, the version of "Intel Management Engine (Intel ME)" didn't change to 8.x (original version was 7.x) .
I tried to install 0048 many times and Intel ME continued 7.x. And (I don't know why ..), I decide to proceed the updating according Intel instrutcions. (I did believe in the tutorial steps!! ).
So, after intall the BIOS 0099,Windows 7 64 bits doesn't BOOT, and I can't even access the MOBO SETUP, unless I PULL the jumper.
I'm really concerned about this and I don't know what to do.
If someone could help me, I'll be thankx!