Hello Everyone
Just to make sure I am not doing something wrong in Basic configuration I ordered a Galileo version one board, too.
Taking it out of the box, connecting the power, connecting the USB gave the expected result. The PC running Windows 8.1 was detecting the board immediately. That is because I installed the USB driver linux-cdc-acm.inf manually already earlier.
I opened the Galileo Arduino IDE. The Arduino sketches can be transferred to the Galileo. But those did not run. There was no activity on outputs or anything.
To solve this problem I made a booting microSD. The is a trig in this process. In the SD card you need to browse to the folder boot\grub. There is the configuration file grub.conf . In that file it is necessary to remove the lines
"
title Clanton SVP kernel-SPI initrd-SPI IMR-On IO-APIC/HPET NoEMU
kernel --spi root=/dev/ram0 console=ttyS1,115200n8 earlycon=uart8250,mmio32,$EARLY_CON_ADDR_REPLACE,115200n8 reboot=efi,warm apic=debug rw
initrd --spi
"
Only after that the Galileo version one was booting from the microSD.
I updated the Galileo version one firmware in Galileo Arduino IDE. Disconnected power. Inserted the microSD. Connected Power. Now it seemed to boot from the SD. The SD light on Galileo was blinking several times over a period of few seconds.
Now everything seems to work correctly on my Galileo version one. It runs the Arduino sketches, etc..
But the Galileo GEN2 with serial number FZGL42602D9R which I ordered two weeks ago from Mouser doesn't work any better with the same microSD card. When I connect the power: The LED ON turns on immediately and stays on. The LED L turns on immediately and stays on for one second. The LEDs SD, OC, USB remain off.
Does anyone know what would be the right procedure to go ahead with my Galileo GEN2 ?